ELECTRICAL MOTOR INSTALLATION PANEL BOARD

This wiring board is a oor standing unit specially design for student to do a wiring on Motor Starter. The unit constructed with heavy steel thickness 3mm and nish with baked epoxy powder. Unit consists of two sections, namely the upper and lower sections. Both sections cover with wing door with lock and door stopper. On the inside of the upper section is tted with a perforated metal panel for quick and easy assembly of motor control components. On the lower section are three level storage compartments for storing Items such as motor control components, cables, hand tools, etc. The panel supplied without any wiring. There is a hole on right side of the panel for cable out from the starter for connection to the motor.

GENERAL SPECIFICATIONS

Wiring exercise based on standard components as follows:

• Direct On Line Starter (single and three phase)
• Forward Reverse Starter
• Star Delta Starter
• Forward Reverse Star Delta Starter
• Auto Transformer Starter
• Rotor Resistance Starter
• Overall dimension (WxDxH): 800 x 500 x 1750 mm

TECHNICAL SPECIFICATIONS

Components/Accessories mounted on the inside panel are as follows:

• 3 x Contactor 3 Pole 415V 5.5kW, coil: 240VAC, contact: 1NO 1NC
  2 x Contactor 3 Pole 415V 11 kW, coil: 240VAC, contact: 2NO 2NC
  1 x Thermal Overload Relay 4 – 6A
  1 x Thermal Overload Relay 6 – 10A
  1 x Timer 1 delay relay 0 – 10sec, with base
  1 x Timer 1 delay relay 0 – 10sec, 1 normal relay with base
  1 x Timer 2 delay relay 0 ~ 10sec, with base
  1 x Timer multi range, with base
  1 x Auto Transformer 10 HP (7.5kW), 2 step (70%), 415V 50Hz.
  1 x Rotor Resistance 5 HP, F.L.S.T 150%, Step 2, star point 1
  1 x Soft Starter 3 phase, 415V 50Hz
  3 x MCB 1P 6A 500V
  5 x Terminal Block 30A 500V
  12 x Terminal Block 20A 500V
  10 x Terminal Block 10A 500V
  Set if DIN rail (mounted at the suitable place to mount e.g MCB, terminal block, etc.)
  Set of PVC cable casing

Components/Accessories mounted on the upper door panel are as follows:

• 1 x MCCB 30A 3P 25kA
  1 x Voltmeter 0 ~ 500V AC/DC with voltmeter selector switch
  1 x Ammeter 0 ~ 20/40A AC/DC with ammeter selector switch.
  1 x Phase Indicating Lights (Red,Yellow,Blue)
  4 x Start Push Button
  3 x Stop Push Button Red
  4 x Pilot Light Green
  3 x Pilot Light Red
  1 x Emergency Push Button
  2 x Door Latch with key

Components/Accessories mounted at leftside (outside) of the panel as follows:

• 1 x CEE Socket Male 32A 5 pole c/w plug

Incoming supply industrial plug and socket (3P- N-E) 32A to trainer panel board
STANDARD ACCESSORIES

• Rubber Mat (WxDxThickness) : 1000mm x 1000mm x 5mm